| Kinefac
Library
June 2003
The only vertical
two cylindrical die rolling
machine
Jan. 2004
Lead &
actuator
screw
rolling
April
2004
TD-21
Kine-Turn
double end
turning
machine
process
steps: boring
for,
assembling of,
and sizing of
bearing
sleeves
June 2006
Robo Roller
Thread and Form rolling system
|
SEPTEMBER'S
NEW
IDEAS THAT WORK |
|
NEW NUMERICAL
CONTROL SPLINE ROLLER |
|
|
|
|
|
Capacity
|
- Splines up to 50mm
diameter
- Pressure angle from 30°
to
45°
- Spline lengths up to
18"
- Shaft lengths up to
48"
|
|
Operator
Friendly
|
- Automatic die matching
- Quick changeover
- Operational flexibility
- Quick die and size
change
- Easy setup - open access
|
|
|
High
Performance at a Low Cost |
- Numerical programming
for: size, rolling rate, die speed, and part feed
- Electro-hydraulic
positioning systems
- Electronic variable
speed system
- Restraint ring spindle
preloading
- Three die system
- Hollow parts with
relatively thin walls
- Constant rolling center
line
|
|
Outstanding
Quality
|
- Tooth to tooth spacing
error below
25 microns
- Pitch diameter
repeatability within
40 microns
|
|
|
|
|
|
This new Kinefac MC-6 FTF NC (H) Kine-Rollerâ
spline rolling system employs numerical
programming for size, rolling feed rate, die speed and part feeding providing the user
with the ultimate
in quick changeover and operational flexibility. The die matching is automatic
through the use of
Kinefac concept die phasing and torque sharing die drives.
The size, rolling feed rate and part feeding are accomplished through
electro-hydraulic positioning
systems. The die speed is controlled through an electronic variable
speed system.
Part straightness and diameter are further stabilized by the use of
restraint ring spindle preloading,
and the initial die step off on the blank assured by driving it in phase
with the dies.
With these unique features, the new MC-6 FTF (H) Kine-Rollerâ
can provide tooth to tooth spacing
error below 25 microns and pitch diameter repeatability within 40 microns on
splines up to 50mm in
diameter with pressure angles from 30°
to 45°.
The use of the Kinefac Three Die System provides
maximum stability for the forced thru feed spline rolling process and
enables the MC-6 system to roll
splines successfully on hollow parts with relatively thin walls.
Click to download PDF brochure
|
|
